Mounting an awning isn t a difficult job.
Tigerz11 awning instructions.
Using your awning rod switch the lever to the open position.
Important safety instructions general safety messages this manual has safety information and instructions to help you eliminate or reduce the risk of accidents and injuries.
All rvs that come with an awning will come with an awning rod as well.
Open awning open awning 1.
Tigerz11 products dedicated off road recovery gear specialists with some of the best value recovery gear ever made.
The best method is to have a roof bar at the rear of the vehicle.
Setting up the tigerz11 awning follows the usual procedure.
Some rvs have a slide mechanism on the awning arm that releases the ratchet by itself.
Awning installation instructions warning.
Credit where credit is due they replaced it on the spot.
Never attempt to repair or disassemble any part of the awning without following.
I bought a tigerz11 awning about a month ago.
The ratchet mechanism should be labeled with both open and close for when you go to switch the lever.
Rear awnings can be the trickiest of all.
When you think about it it would take someone a day to write better instructions with better diagrams but it s that attention to detail you just shouldn t expect to.
This feature is not available right now.
Unzip the bag fold out the struts and extend the awning by unrolling it from the end bar.
Failure to follow these instructions could result in personal injury.
Do not remove the plastic safety sleeves from the lateral arms until instructed to do so.
The 1st one was taken back due to the external bag being ripped.
Rating is available when the video has been rented.
The interactive transcript could not be loaded.
Aluminium mounting rails which should be supplied with your awning clamp to the bar with sandwich clamps and you can then bolt the awning to those.
This is where i got my first reminder of that i had bought cheap as the instructions where just a crappy photocopy with bad diagrams and wirten in un interpretable chinglish.
Clip the struts into the end bar lower the legs and adjust them to the height you want then do up the velcro straps that hold the canopy to the struts.
