You ll want to use 120 150 grit sandpaper and sand lightly.
Stripe paint off frooves wall panelling.
To be sure try the steps below on a small area before deciding to remove the paint on the entire wall.
Sanding is the number one way to remove paint from wood paneling.
Apply a thin coat of your paint to all paneling surfaces.
Scraping the paint with a putty knife can damage the wood underneath it.
Begin at the top and work your way down making sure to cover all the gaps between the panels.
Paint the paneling in a base color such as white tan or gray.
If your walls have a vinyl or thin veneer finish you ll need to take extra care when painting them.
Use a brush to fill in any grooves.
Tape off the ceiling and trim and cut in paint along the tape creating a border of paint all around the room or the section of wall to be covered.
If the paint is very thick and uneven switch to a 40 grit sanding disk.
Apply a thin coat of primer with a roller.
To fix these paint streaks on walls you ll need to sand down the raised edges.
Instead you must dissolve the paint and gently scrub it off with a soft bristle brush.
Use just enough pressure to take off the paint.
Remove any excess paint that collects in the panel grooves using your brush.
Since paneling already has grooves that divide the surface into sections use paint to create a striped effect on the wall.
How to paint stripes on your walls.
To check sand a small area on the wall.
Before painting paneling use painter s tape to mask off your mouldings windows doors and ceiling.
Let stripes dress up the look of your room.
Allow the primer to dry a full 24 hours before painting over it.
Some paneling actually consists of a vinyl print that simulates the look of wood.
You can either work with a hand held sander or just a piece of sandpaper.
If there are several coats of paint you may want to use a stripper first.
When you re ready to start painting make sure that your paneling is made of solid wood.
Also try not to sand or scrape off the paper surface of the drywall.
Sanding too hard can take off the flat paint which would mean another coat application.
For the best finish paint paneling methodically.
If you re lucky the paint will come right off with just a bit of wiping.
You may want to start with a just a piece and work with that especially if you are new to sanding.
Remove the painter s tape before the paint dries.
Vinyl coatings come off quickly revealing the pressboard underneath.
Do not let the sander linger over any spot as it may gouge the drywall.
Pull off the tape slowly peeling it and folding it back on itself.
You may have to touch up the wall here and there but that s only if you sand too closely.
Removing paint from paneling is a delicate process if you want to preserve the paneling because you can t scrape the paint off.
All you need is tape paint and a little creativity.
